Author Topic: unable to entirely close switcher shield

November 14, 2023, 06:24:33 PM
Read 1258 times

rolly

  • Newbie
  • *
  • Posts: 9
  • Karma: +0/-0
    • View Profile
Hi,

finally i found some time to build the 501, but i'm not able to get the switcher PCB properly shieled.
Inductors have been installed as close as possible to the PCB but the coil's wire ends are causing a gap of 2-3mm, making it impossible to entirely close the switcher shield on this side.

How critical is this? Can i continue troubleshooting my noisy 573 and sort this out later?


regards
Oli

« Last Edit: November 14, 2023, 06:28:58 PM by rolly »

November 14, 2023, 06:33:32 PM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 1118
  • Karma: +37/-0
    • View Profile
No real problem because electrical continuity is provided by the connectors.
JPK