Author Topic: TL074L replacement

August 17, 2022, 10:36:36 AM
Read 833 times

tgs76

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Hi all,
I have had a problem with an MP573 that I built recently where the LED doesn't work. I just found some time to troubleshoot it and noticed a glaring mistake: I've put on the TL074L backwards. :P I'll try to desolder it but I don't anticipate much luck with that. So I'm looking for a replacement but in the store I normally order from (Elfa/Distrelec in Sweden) don't have that exact model. What they have are TL074CDT and TL074IDT, both SMD and smaller. Also did a search on Mouser although a bit wasteful to order from them for a 1€ part) but they don't seem to have it either actually.

Any recommended replacement? I've Googled a bit but admittedly I'm a bit novice so I'm not exactly sure what to look for.

August 18, 2022, 10:40:15 AM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 998
  • Karma: +29/-0
    • View Profile

August 20, 2022, 07:08:27 AM
Reply #2

tgs76

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Thanks JP! I managed to get a TL074 from Volker. I'll remove the current one as suggested. I might as well order some sockets while I'm at it, always good to have.

August 20, 2022, 10:02:15 AM
Reply #3

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 998
  • Karma: +29/-0
    • View Profile
I don't think you can put a socket here because the allowed height is limited by the DI board above.
JPK

August 20, 2022, 10:20:47 PM
Reply #4

tgs76

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
I don't think you can put a socket here because the allowed height is limited by the DI board above.
Aware of that and will test before soldering anything in place.