Author Topic: Output transistor bias issue?

May 10, 2022, 03:59:13 PM
Read 733 times

MDR

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Hi,

Just built a 573, all is working and the unit seems to sound good.

However, when I adjusted the bias of the output transistor, I couldnt get TP4 to go below 3.8v.  It started off around 5v, but wont adjust lower than 3.8v.
Is this a problem or within tolerance? 

May 11, 2022, 11:50:09 AM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 998
  • Karma: +29/-0
    • View Profile
This is not normal and the transistor Q6 will get too hot.
Please report the DC voltages shown here: https://www.soundskulptor.com/forum/index.php?topic=5.msg5#msg5
in particular in points G to L.
JPK

May 14, 2022, 05:05:17 PM
Reply #2

MDR

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Ok I dont know what happened but when I went through measuring all of those points, I found the bias voltage was down around 1v and was able to adjust it up to 3v.  So it seems to be fixed.  Perhaps I was measuring the wrong point the first time around.  
Thanks for your help.