Author Topic: Shut down tube while not in use

November 25, 2021, 09:36:20 PM
Read 1016 times

Antipathie

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Hi everyone,

since that's my first post I hope, no one has ever raised that question :)

I have a MP566 and like it pretty much. However on many occasion I use my 500 rack but won't touch the 566. I assume the tube is powered up the whole time, right? Is there a way to turn off the tube like it is on guitar amps?


November 26, 2021, 08:36:11 AM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 998
  • Karma: +29/-0
    • View Profile
A connection that would discharge C25 (like a 1k resistor across the pins) would shut down both the heater and the high voltage.
JPK

June 15, 2023, 08:39:01 PM
Reply #2

jtyghe

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
I’m interested in this too. Would putting the resistor work as JPK mentioned, so that when I switched it to mute the transformer and valve would be starved of power and therefore be off? 
Also wondering if it’s possible to have somehow add a bypass switch or have the channel be bypassed when in mute position?

Thanks

J

June 16, 2023, 11:49:01 AM
Reply #3

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 998
  • Karma: +29/-0
    • View Profile
You could disconnect the mute switch from the circuit (by cutting some tracks), reconnect the output transformer primary to the signal (TP4) and to ground and use the switch to cut the tube power and activate a bypass relay.
But this is a lot of modifications!
JPK