[aktivomat]

Hello! 

First I just wanted to post my test results to confirm if these are "ok". Especially because I built two units hoping to use them in the 2-bus. At 80 Hz I see quite a "drift" from the "norm" on both units, or is this "ok"? Something i should do/change/calibrate? I did the test with two different DMMs with quite same results. Unfortunately none of them get the 10kHz :-(

 Second: Is it possible that with 30 IPS there is no "roll-off" at all in the hights?

Thank you so much for your assistance and kindest regards,
Ivo

[JPK]

Your results are good.
The variation between units comes from the absolute value of the pots which are specified at +/-20%.

[aktivomat]

Your results are good.
The variation between units comes from the absolute value of the pots which are specified at +/-20%.

Thank you very much for your reply! So I’m happy :-)

Please could you also answer my second question: Is it “normal” that with 30 IPS there is no "roll-off" at all in the hights?

[JPK]

Yes it is normal. The high freq roll-off only happens at 7.5 and 15 ips.

[aktivomat]

Thank you!