Author Topic: How much deviation of the voltages is acceptable during setup?

October 19, 2023, 12:09:31 PM
Read 208 times

ddld

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Hi,

I'm in the setup process. According to the setup manual, the voltage between TP1 and V+ should be 'approximately' 24.2 volt without the transformer, and 'a little lower' with the transformer. I am seeing exactly 25.08 volt in both cases. Is that a reason for concern, or does it fall within the tolerances?

October 21, 2023, 09:34:32 AM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 1015
  • Karma: +30/-0
    • View Profile
The measured voltages depend on the actual PSU of your lunchbox so a 10% deviation is acceptable.
Plugging in the output transformer should show a small decrease in the V+ voltage.
If it doesn't, check your output tansformer connections, verify the output transformer DC resistances.
JPK