Author Topic: AB528 DI not working

August 28, 2023, 03:29:51 PM
Read 1170 times

Greg

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
I just finished putting together the AB528 and mic input works fine and seems to be doing what it supposed to. The only problem I have run into is that the DI doesn't seem to work. I can turn it up  full and hear white noise but, no other signal than that. I also don't hear the relay switch click when I insert cable. All of the connector connections on the DI board check out. Any suggestions or troubleshooting I could do? 
Thanks in advance!

September 02, 2023, 10:15:51 AM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 1118
  • Karma: +37/-0
    • View Profile
Does the XLR input still pass through when there is a plug in the DI input?
JPK

September 13, 2023, 08:40:16 AM
Reply #2

Greg

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Hi there, thanks for getting back to me, much appreciated and apologies for late reply!

I just had another look and I do actually hear the sound of the relay clicking. Still not getting any signal from the DI. 
Have tried using a mic and then plugging into DI the mic signal does shut off. 

September 13, 2023, 08:52:15 AM
Reply #3

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 1118
  • Karma: +37/-0
    • View Profile
Send a 1VAC sine signal into the DI input and check if you can measure it on U2 pin1 (the square pin) against 0V. You should read 1VAC on the meter.
Also check there is no DC voltage on this pin.
If all OK, the issue must be on relay RLY1.
JPK