Author Topic: Have I ruined my PCB ?

December 14, 2021, 02:56:03 PM
Read 1333 times

lemusicien

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Hi everyone Bonjour JP
So far it's been awesome but i manage to mount the CN3A on the wrong side.
it took me a bit of work with a solder sucker but finally manage to pull it out.

Now I can see some coper (i guess) from the pcb and I'm really concerned I've ruined !
I'd like to know before soldering on the right side this time..

Can you tell me what you think ?
Merci d'avance, Vincent


« Last Edit: December 14, 2021, 02:58:03 PM by lemusicien »

December 15, 2021, 04:59:28 PM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 998
  • Karma: +29/-0
    • View Profile
Check that the vias are OK. They connect the top and bottom pads.
What is your PCB revision?
JPK

December 15, 2021, 07:36:10 PM
Reply #2

lemusicien

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
REV1.3

Well I checked with the multimeter the top with the bottom of the damaged pads it seems there is continuity!
The damage is only on the surface of the pcb but some pads seem to touch with the copper wiring so I was afraid.

DO you think it's fine ?

December 16, 2021, 10:28:47 AM
Reply #3

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 998
  • Karma: +29/-0
    • View Profile
You should also check the connections shown in the attached pic.
JPK

December 16, 2021, 12:11:21 PM
Reply #4

lemusicien

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Thanks JPK, 
I triple checked.

There is continuity everywhere. 👍