Author Topic: connector missing

December 05, 2021, 06:15:53 pm
Read 445 times

Tonader

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Hey guys, im in the middle of this project. I just want to mention that im missing the connector for DI Port in this package. For now im relaxed with that :-)

But the main question is: can i safely skip the DI board as long as i would never use it? Im to lazy to solder a board that is only for decoration...... If it would not disturb the system at all.

Thanks and best !

December 06, 2021, 08:57:33 am
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 585
  • Karma: +14/-0
    • View Profile
You can skip the DI completely as long as you insert the jumper on JMP1.
Please send us an email here so that we can send you the missing part.
JPK

February 09, 2022, 06:14:18 pm
Reply #2

FastnBulbous

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Is the purpose of JMP1 just to disable the DI?  So for normal use the jumper shouldn't be installed? Thank you!

February 10, 2022, 12:20:29 pm
Reply #3

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 585
  • Karma: +14/-0
    • View Profile
Correct.
The jumper JMP1 forces the XLR input. It is only to be used during initial testing without the DI board installed.
JPK