Author Topic: R10 Burnt on

November 14, 2021, 12:59:58 PM
Read 1390 times

F.R:

  • Newbie
  • *
  • Posts: 12
  • Karma: +0/-0
    • View Profile
I triplechecked the layout before setting the DOA in as mentioned in the calibration-guide building the CP5176. R10 on the DOA and R56/57 on the main PCB burnt immidiatly at step 6 where i insert the DOA. I read a topic about what to do if r56/57 burns and ordered a new SK25 and also went shopping for some backup resistors and stuff. Strange to me is what caused the DOA itself fail at R10 and what might have caused it which i didn't see on a triple check.

thanks in advance F.R.

November 15, 2021, 10:21:13 AM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 999
  • Karma: +29/-0
    • View Profile
Swapped Q9 -Q10 ?
JPK

November 15, 2021, 04:50:01 PM
Reply #2

F.R:

  • Newbie
  • *
  • Posts: 12
  • Karma: +0/-0
    • View Profile
What else...fml..TY. As stated above I ordered a new one already, still wondering if it would work, when I swap out Q9/-10 and the failed resistor as some sort of spare part..or if there might be more broken so it's not worth keeping it.

November 17, 2021, 05:43:37 PM
Reply #3

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 999
  • Karma: +29/-0
    • View Profile
Not sure.
One failure often cause other components destruction.
You must first find out the reason of the issue.
JPK

November 26, 2021, 06:13:55 PM
Reply #4

F.R:

  • Newbie
  • *
  • Posts: 12
  • Karma: +0/-0
    • View Profile
It was the Q9/10 swap in the end..only failing parts where the 3 resistors...but disassembling the DOA was...let's say not quite worth the time not even for spare parts...the new one did the job, and the "CP 5176" is already on duty. Thanks for your time and very well written documentations. This was totally on me^^

November 29, 2021, 05:57:15 PM
Reply #5

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 999
  • Karma: +29/-0
    • View Profile
JPK