1

TS500 Tape Simulator / Re: TS500 different version out of phase?

« on: October 24, 2023, 09:28:19 PM »

Great! Thank you 👌! Just to be on the save side… REV 1.4 is certainly affected by the problem, right?

2

TS500 Tape Simulator / Re: TS500 different version out of phase?

« on: October 21, 2023, 03:19:21 PM »

Hey JPK!

I think I have the same phase issue (REV 1.4). Could you please upload the modification pdf again?

Thank you very much and kind reagards!

3

TS500 Tape Simulator / Re: Test results and question (30 IPS "roll-off" in the highs)

« on: March 15, 2023, 11:48:48 AM »

Thank you!

4

TS500 Tape Simulator / Re: Test results and question (30 IPS "roll-off" in the highs)

« on: March 15, 2023, 11:37:41 AM »

Your results are good.
The variation between units comes from the absolute value of the pots which are specified at +/-20%.

Thank you very much for your reply! So I’m happy :-)

Please could you also answer my second question: Is it “normal” that with 30 IPS there is no "roll-off" at all in the hights?

5

TS500 Tape Simulator / Test results and question (30 IPS "roll-off" in the highs)

« on: March 05, 2023, 04:53:52 PM »

Hello! 

First I just wanted to post my test results to confirm if these are "ok". Especially because I built two units hoping to use them in the 2-bus. At 80 Hz I see quite a "drift" from the "norm" on both units, or is this "ok"? Something i should do/change/calibrate? I did the test with two different DMMs with quite same results. Unfortunately none of them get the 10kHz :-(

 Second: Is it possible that with 30 IPS there is no "roll-off" at all in the hights?

Thank you so much for your assistance and kindest regards,
Ivo