Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Fabrizio A

Pages: [1]
1
Thanks, 
the results are what you wrote, I was wrong to measure.

The preamp sounds fantastic, Thanks


2
hi JPK,
Thanks for the reply,
I did a check of all the welds and now the preamp works very well but on pin 3 and 2 of the XLR input I don't have the results you wrote me

3k69 with impedance 1200 and 300
5k switch on line

very different from your values, but it works
what do you think?
thank you


FABRIZIO

3
ciao ho bisogno del tuo aiuto
Ho costruito un MP573 che ha superato i test di installazione.
Ha funzionato per circa 2 settimane con un suono davvero molto interessante. Ieri mattina mentre lo stavo usando con un U87 si è spenta 2 volte e il preamplificatore ha smesso di funzionare. Vedo il segnale in ingresso attraverso il led ma in uscita sento un segnale molto basso senza frequenze basse, anche dalla DI e grande rumore tipo pink noise

Ho fatto i test approfonditi che danno i seguenti risultati:
R: 2.6
B: 4.09
C: 22
D: 13.5
E: 2.0
F: 12.9
G: 0,9
H: 4.14
Io: 0,34
J: 3.55
K: 22.6
L: 3

mi sembrano tutti ok

poi ho seguito il segnale ed ecco alcuni problemi che non capisco bene:

tra i pin 2 e 3 dell'XLR 1,6 VAC
pin di ingresso del trasformatore 7: 0,018
tp1: 0,1
il filo giallo dal trasformatore di uscita dà un risultato instabile

trasformatori resistivi ok tranne VTB9045
tra 7 e 9: 138.2
tra le 8 e le 10: 136,7

Sento solo un relè all'accensione e uno allo spegnimento, non quando passo dalla linea a 300 a 1200.

il Q6 riscalda di circa 50 gradi
Ho controllato tutte le saldature ma dà sempre lo stesso problema

Penso che abbia bruciato i 220V, pensi che sia possibile?
oppure si è danneggiato a causa di un problema con la 220V?
Mi potete aiutare?

Grazie Fabrizio

Pages: [1]
SMF spam blocked by CleanTalk