1

LA502 Optical Compressor / La502 doesnt reach 15V AC

« on: January 04, 2022, 10:34:27 AM »

Hi,

When calibrating the 502, I can follow all the steps, but when indicated to turn the gain up to get exactly 15V AC, i can only reach 11.4V

The rest of the setup I can follow no problem, and the module works ok.

Should i be concerned? Anywhere where I could check?

Thanks

2

EQ573 Equaliser / EQ573-II boost | cut not working on three bands. Help! SOLVED

« on: December 10, 2021, 12:55:14 AM »

Edited: 

Problem fixed, cheers

Hi,
I just finished one of these.
I Have a problem with all 3 cut/ boost middle knobs, they are not working.
Also the mid frequency outer pots doesnt work either.
Rest of the module is working fine.
I saw a few posts mentioning the module, but the all refered to v1. Do these apply to v2?
Is there a guide where to check voltages?
Any recommendations where i should start?
Cheers

3

First Aid / 501 connector polarity with xt500 and jumper pins settings??

« on: November 26, 2021, 10:04:35 PM »

Hi!
New member here

I just finished a 501 host and i have added a xt500 extender.

I this the correct orientation?

Picture

Do i have to place the jumpers on the 3 rows in any setting?

Apologies its my first 500 build, cheers

Ps: the yellow tape is to avoid contact between the switcher botton pcb and the blue conector.