Sound Skulptor forums

Build help and troubleshooting => CP5176 FET compressor => Topic started by: Steggi on June 21, 2022, 11:31:31 AM

Title: Output Sound with no Low End after Setup
Post by: Steggi on June 21, 2022, 11:31:31 AM

Hello,

i followed the Setupguide and all Values were fine. I send some Samples through the Compressor and it Sounds like there’s an Highpass Filter on it.
I already ordered a new SK25,
because i measured 0.525V at Top Pin L1 when the Compressor isn’t working. After my research you said that this could mean that there is a problem with the DOP. Maybe there is another Problem. Can you hep me out?

Greetings from Hamburg

Title: Re: Output Sound with no Low End after Setup
Post by: JPK on June 21, 2022, 04:42:16 PM

it Sounds like there’s an Highpass Filter on it
This is often caused by an incorrect wiring in or out. The input and output are floating and both hot and cold need to be connected.

Title: Re: Output Sound with no Low End after Setup
Post by: Steggi on June 21, 2022, 04:51:35 PM

Allright, i’ll go check the wiring this evening and also try another Slot of my Lunchbox. 
But I know that Slot that I used worked fine in the Past. I’ll let you know what i find out. 
Thanks a lot for your answer!

Title: Re: Output Sound with no Low End after Setup
Post by: Steggi on June 22, 2022, 06:28:46 AM

I had to resolder some connections at my extender cable. 
Everything’s fine now :) 
Thanks for the help!