Sound Skulptor forums

Build help and troubleshooting => DI503J Triple DI and Re-Amp => Topic started by: slynch on February 10, 2026, 05:39:49 PM

Title: Broken pads on potentiometer board
Post by: slynch on February 10, 2026, 05:39:49 PM

Well this one really hasn't gone well for me. I think I went too fast and I ended up having a few major mistakes in my build. I thought I had eventually figured it all out and fixed the issues but...

One of the major issues was that I accidentally switched the potentiometers P1 and P2. When I realized this, I removed them and installed them in their correct location, but I damaged the board in the process. I confirmed that at least one pads under the pot was lifted or damaged.

So what's the process to get this fixed now if the board is bad?

Title: Re: Broken pads on potentiometer board
Post by: JPK on February 12, 2026, 02:59:45 PM

It is possible to repair by soldering a wire between the pot pin and the circuit.
Which pad of which pot is damaged (or show a picture) ?