Sound Skulptor forums
Build help and troubleshooting => LA502 Optical Compressor => Topic started by: UrbanOsterman on July 05, 2025, 03:20:41 PM
-
Hello
When I insert my LA502 into my Microphone-preamp-chain, I loose a bit of Bottom from my Sound.
Is there a way not to loose the lower frequency in the LA502? or is it part of the design?
Is this normal or did I make some error in my soldering?
My Chain is Mic/SM58 into AB528 into LA502.
Maybe it is some sort of Impedance issue?
I hear that I loose some bottoms on my voice.
I try to insert som pink noise instead of talking into the mickrophone.
But its hard to se in the spectrum analyser.
Regards
Urban Osterman