The PAD500 is a dual balanced line attenuator. It is used after a mic preamp or any effect that you want to drive hot without clipping your converters.
There are 2 attenuators available: One is wired between the in and out XLR's at the back of the lunchbox, the other between the 2 jacks at the front.
Absolutely everything!
You bring the solder (use good quality solder, 1mm diameter max) and the Lunchbox.
The PAD 500 is our easiest kit.
XT500 Extender: The XT500 option is a cable extension that allows you to test and setup the module outside the lunchbox while connected.
501 Case: The 501 case option is a standalone, single slot lunchbox with PSU.The XT500 Extender is not needed with the 501.
Assembled Product: If you prefer not to DIY, choose an Assembled product. It comes fully assembled, ready to use.