MP512

The MP 5.12 is based on one discrete Op-Amp, one Cinemag input transformer and one Cinemag output transformer.

It delivers what is called the "LA" sound, popularised by the famous American consoles of the 70's : the punchy midrange and tight bass tone of the iron. This MP 5.12 is great on drums, electric instruments and generally all close miked sources.

Just install it in your API* compatible Lunchbox^TM rack and start recording.

Highlights

• Discrete Op-Amp (DOA) pinout compatible with the API* 2520
• Original Cinemag (Reichenbach) transformers on input and output
• 70 dB of gain
• Dual track gain potentiometer for precise gain setting, even in high gains
• Variable output pad for those who like to drive it hot
• Fet DI input, relay switched, the signal passes through the input transformer
• Signal/Clip LED monitors signal with full wave rectifier
• All low level signals switched by relays
• Golden contacts on relays and switches
• Nicely damped quality conductive plastic potentiometer
• 1% metal film resistors
• High grade 105°C low ESR electrolytic capacitors
• High grade double sided PCB with plated holes
• Available assembled or as a full kit (everything included)

What's in the kit?

Absolutely everything!

• Passive components (resistors, capacitors),
• 2 Cinemag transformers
• Active components (diodes, transistors, LED, ...),
• SK25 DOA kit,
• Front panel elements (switches, potentiometers, knobs),
• Connectors, relay,
• PCB's,
• Front panel and side panel,
• All hardware

You bring the solder (use good quality solder, 1mm diameter max) and the Lunchbox.

Difficulty level

The MP512 kit is an easy build. The DOA is a little more difficult because of the components density.

Product Options

XT500 Extender

The XT500 option is a cable extension that allows you to test and setup the module outside the lunchbox while connected.
You get a discount when you puchase it as a Kit option.

Go to the XT500 page

501 Case

The 501 case option is a standalone, single slot lunchbox with PSU.
The XT500 Extender is not needed with the 501.

You get a discount when you puchase it as a Kit option.

Go to the 501 page

Assembled Product

If you prefer not to DIY, choose an Assembled product.
It comes fully assembled, ready to use.

Technical specifications

 

Documents

  Go to Products technical documentation

  User manual